SolarVenti SV2 - Slim line is typically mounted on wall - but can also be roof mounted. SV2 has the same fan and sun cell as its elder brother SV3, but the SV2 panel has equal length and width. Therefore this model is well suited for putting 'on point tip' on wall or roof. That is also why it has got it's nickname "Diamond".
The amount of hot air from the small models, does not exceed levels for temperature and m3 that makes thermostat/regulator unit necessary. That is why SV3 and SV2 as standard are delivered only with on/off switch.
What are the main benefits of a SolarVenti?
*Can be used in nearly all climate zones.
*Flexible in design multiple shapes
*High quality and reliable under all weather conditions
*No breakdown due to overheating is self-cooling (patented solution)
*Is maintenance free for 10-15 years due to a simple filter-solution
*Is a low-tech and a simple construction
*No operating cost and free of CO2, since it is 100 % powered by the sun through a solar cell and doesnt need to be connected to the grid.
*Is not necessary to turn on or off that is taken care of by the sun
*Improves the indoor climate and reduces problems for people suffering from allergies
How is the SolarVenti unit installed?
Because of its simple design and lightweight it is easy to install. Since there is no electric or special wiring, many homeowner can install the unit others may hire someone to install it. The smaller units can be installed in a matter of hours. Everything that you need to install it comes in the in the box.
SolarVenti has been manufacturing solar air ventilation products since 1981 and can be found in Greenland to Australia as well as other 25 countries around the world. Invented by Hans Jorgen Christensen of Denmark, one of leading experts in the world regarding solar air collectors, SolarVenti has over 35,000 customers around the world.
If you own any of these below:
*Damp houses
*Second homes
*Basements
*Campers and Trailers
*Garages
*Houseboats, etc.
*Warehouses
*Crawlspaces
*Attics
*FarmHomes
How Does It Work?
The SolarVenti solar air collector entire back plate is perforated by tiny holes that sucks in air into the solar panels and in a controlled manor so the combination of heat and airflow can be exploited optimally. This means that the solar air collector can be made significantly smaller, elegant and in multiple shapes. The perforated back plate also means that the solar panel cools itself when the fan is off.
How is it Powered?
The SolarVenti solar air collector can run by itself, without being connected to the grid or other electrical power system and without manual control since it is powered by an internal solar panel. It turns itself on and off depending on whether the sun shines and therefore has no operating cost
Its structure and its components are so simple that the SolarVenti unit is both very inexpensive and is maintenance free for 10 -15 years.
Here are the different size models:
SV2
SV3
SV7
SV9
SV14
SV30
What shape and Sizes is it made?
SolarVenti comes in several shapes and sizes ranging from the SV2 model is less that 2 x 2 x 3 x 2 and works in a 200+ sq/ft room with the largest unit, the SV30 is 34 x 9 x 3 and can ventilate rooms over 1,500 sq/ft.
What are the Other Products that SolarVenti Make?
* Hot Water Heaters
* Swimming Pool Heaters
* Ground Cooling Kits
Mounted on: Wall or roof
Rooms: Normally covers at least 15 m²
Maximum performance: 200 watt
Capacity fan: 70 m3/hour
Performance fan: 15 30 m3/hour
Size: 52,4 x 52,4 x 5,5 cm
1'7" x 1'7" x 2"
Online Shopping
